Skip To Content

Setup Instructions

Setup Instructions

Mounting Options

It is important that you are familiar with the machine your EZ-Puller will be used in. If the machine has a wedge lock mounting system for holding square tooling, the body of the bar puller may cover the outboard tightening bolt. If this is the case, the tool will need to be moved away from the center of the turret to access that bolt. Many times, this will cause interference with the way covers of the machine. If this is the case, the better mounting option is the 1.000″ round mounting, either standard or low profile. With this option, the tool will be held in an I.D. tool holder. Please look at the pdf diagrams below of mounting options before ordering.

 

EZ-Puller Low Profile Mounting Bar

EZ-Puller Round Mounting Bar

EZ-Puller Square Mounting Bar

It is important that you are familiar with the machine your EZ-Puller will be used in. If the machine has a wedge lock mounting system for holding square tooling, the body of the bar puller may cover the outboard tightening bolt. If this is the case, the tool will need to be moved away from the center of the turret to access that bolt. Many times, this will cause interference with the way covers of the machine. If this is the case, the better mounting option is the 1.000″ round mounting, either standard or low profile. With this option, the tool will be held in an I.D. tool holder. Please look at the pdf diagrams below of mounting options before ordering.

 

EZ-Puller Low Profile Mounting Bar

EZ-Puller Round Mounting Bar

EZ-Puller Square Mounting Bar

It is important that you are familiar with the machine your EZ-Puller will be used in. If the machine has a wedge lock mounting system for holding square tooling, the body of the bar puller may cover the outboard tightening bolt. If this is the case, the tool will need to be moved away from the center of the turret to access that bolt. Many times, this will cause interference with the way covers of the machine. If this is the case, the better mounting option is the 1.000″ round mounting, either standard or low profile. With this option, the tool will be held in an I.D. tool holder. Please look at the pdf diagrams below of mounting options before ordering.

BigEZ Low Profile Mounting Bar

BigEZ Square Mounting Bar